Posts Tagged ‘Mars Science Laboratory’

Mission Control to Mars: Launching the Next Mars Rover

Monday, November 28th, 2011

By Rob Manning

In the wee morning hours of Nov. 26, 2011, scientists and engineers gathered in the mission control room at NASA’s Jet Propulsion Laboratory to help launch the next Mars rover, Curiosity. The mission’s chief engineer, Rob Manning, shares the developing story from the control room as tensions and excitement for a mission eight years in the making reached all new heights.

NASA's Mars Science Laboratory spacecraft, sealed inside its payload fairing atop the United Launch Alliance Atlas V rocket
NASA’s Mars Science Laboratory spacecraft, sealed inside its payload fairing atop the United Launch Alliance Atlas V rocket, launched on Nov. 26 from Kennedy Space Center in Florida.

5:45 a.m. PST (L-01:17:00)
I drove in this morning at 4:30 a.m. As usual, I was greeted by the cheery guards at the gate along with a small family of local deer, who keep sentry over a small patch of greenery at NASA’s Jet Propulsion Laboratory.

I quickly march into JPL’s mission control area to find the first shift quietly following the prelaunch procedure in sync with the Assembly, Test and Launch Operations (ATLO) procedure. They had been on station since 1:30 a.m. I tried that procedure at last week’s launch rehearsal and found the hour a bit unpleasant. Today, I am working on the Anomaly Response Team (ART) for post-launch anomalies. This means that if all goes well, I will have little to do but cheer when NASA’s Mars Science Laboratory rover launches. I have my own console where I can monitor both the spacecraft and listen to the voice nets (there are 10 of them!).

There are about 30 people here. Usually there are not as many, but today we have two people for every subsystem: power, thermal, propulsion, systems, fault protection, attitude control and management. I can hear the JPL ATLO test conductor, Art Thompson, at NASA’s Kennedy Space Center in Florida double check that the right sequence files have been sent. One in particular has commands that tell the rover when to automatically transition into “eclipse” mode. This software mode puts the entire vehicle into the configuration needed for the period prior to separation from the Centaur. In particular this mode turns on the descent stage and cruise stage tank heaters. This timer should be set about 15 minutes after launch, which is planned for 7:02 am PST today. It is an absolute time so they have to send a new time every time we have a new launch attempt. The voice net that is the most interesting is the launch vehicle’s fueling operations. I have not heard that one before. They are more than 50 percent of the way through fueling!

It is fun to see the crowd here. No dress code, but some have come in ties, others with pink mohawks. Nice combo. Professionals all. The peanuts have already made the rounds.

6:15 a.m. (L-00:47:00)
Brian Portock, today’s flight director at JPL, just finished the launch poll of the room to see if everyone is go for transition to launch mode. This is a command to the rover that will put everything on the rover into a mode that is used for the first 15 minutes of flight. In particular, the heaters are all put into a launch and cruise configuration. We expect that the cruise stage heaters will be on more than off due to the air conditioning needed to keep the spacecraft cool (hot generators, you know).

6:29 a.m. (L-00:33:00)
Arm pyros! Once these relays are closed, they will be that way for the next 8.5 months.

6:32 a.m. (L-00:30:00)
The data rate is lowered to launch nominal to 200 bits per second. This will allow the rover’s data to flow to both the ground (via wires to the power van at the foot of the launch pad that provides power to the rover before launch) and to the launch vehicle where it will be available throughout launch (very cool). The JPL management showed up. Charles Elachi is behind me. My old friend and JPL Chief Engineer Brian Muirhead is here with his family.

6:40 a.m. (L-00:22:00)
The flight director is doing the launch poll for the team here at JPL: “All stations at JPL report go.” ATLO is going through its poll at lightening speed. All stations go. This is going fast! The weather guys report of scattered skies at 5,000 feet looks good. I am getting excited.

6:47 a.m. (L-00:15:00)
We lost the flow of data from MSL via the Atlas Space Flight Operations Center (ASOC) land lines, but they switch it to the radio path from the launch vehicle, and it starts flowing again.

7:00 a.m. (L-00:02:00)
All Quiet. Peanuts going around the room again … everyone is excited!

7:01 a.m. (L-00:01:20)
Everything is armed …

7:01 a.m. (L-00:00:30)

7:03 a.m. (L+00:01:00)

7:06 a.m. (L+00:04:00)
Fairing falls off! Wind on MSL ;)

7:07 a.m. (L+00:05:00)
Rob Zimmerman, our power systems engineer, reports power on solar arrays! 3.3 x 2 = 6. 7 amps! The spacecraft is still power-negative for a while which means that the battery is still discharging. We need more sunlight - very soon.

7:11 a.m. (L+00:09:00)
Getting intermittent data from the rover via the Centaur. So far, no computer reboots!

7:12 a.m. (L+00:10:00)
The ATLO test conductor reports that they are done building and launching MSL (hey, it took ‘em long enough! ;) ). We all cheer and smile. They are supporting the cruise team now.

7:14 a.m. (L+00:12:00)
We’ve reached the end of the first burn (MECO1). All is well. Eighteen minutes to second burn. Battery is charging at 4.3 amps for each battery — very good.

7:17 a.m. (L+00:15:00)
The eclipse-mode transition should be done; don’t know yet. Got it. The tank heaters should be on now; They are. Batteries are still charging at 95 percent state of charge (SOC).

7:35 a.m. (L+00:33:00)
Waiting for telemetry from over Africa …

7:36 a.m. (L+00:34:00)
It’s five minutes to MECO2, pushing out of Earth orbit. Heavy rover! KEEP PUSHING! Mars awaits.

7:39 a.m. (L+00:37:00)
The spacecraft is nearly out of Earth orbit, six minutes until separation from Centaur upper stage. Everyone is relaxed, but there’s not a lot of data from the rover. It still says it is in launch mode — missed the data that said eclipse.

7:42 a.m. (L+00:40:00)
MECO2. next is turn to separation attitude and spin up. Separation! We get a beautiful view of MSL spinning away from us — in the right attitude and the right direction! (› See Video)

Video: The Mars Science Laboratory spacecraft separates from the upper stage of its Atlas V launch vehicle and heads on its way to Mars.
› See video

7:53 a.m. (L+00:51:00)
We have lock from NASA’s Deed Space Network in Canberra, Australia!

8:07 a.m. (L+01:05:00)
Data-slowing coming … All looks good, batteries at 98 percent. The rover is now in cruise mode. The heaters are on and cycling as designed. The spacecraft is spinning at 2.5 rotations per minute with only 1 degree of nutation (or swaying) — that is not a lot. The Atlas and Centaur did a fantastic job! The generator is working.

8:26 a.m. (L+01:24:00)
Now let’s try the uplink (sweep). Sweep is working! We have strong signals both ways. We are getting two-way Doppler - navigation says that the frequency is just a few hertz off so we had a very nominal injection to solar orbit. We can command!

Everyone is relaxed and trying to see if there is anything that looks wrong, but so far, nothing. Everything is fine. This is weird. Our bird is on its way - it’s where it belongs. We are happy to be in a completely new mode. No more last-minute fixes (to anything but the software). We have a lot to do, but at least our bird is on its way.

Out of This World (Literally): Week One

Friday, June 24th, 2011

By Andrew Crawford

He’s already been a classical violinist and a professional snowboarder. Now mechanical/aerospace engineering student and Montana-native Andrew Crawford is learning what it’s like to be an intern at NASA’s Jet Propulsion Laboratory. This summer, he’ll share his experiences working in the Deep Space Network’s Antenna Mechanical group. Read his full blog on the JPL Education website.

Jason Carlton oversees transportation of the Mars Science Laboratory rover
My mentor Jason Carlton oversees the high-bay hoisting of the spreader bar used to lift and stack the Mars Science Laboratory rover Curiosity and the rover container. Does it get much cooler than bunny suits?!

Checking in … beep-beep … beep-beep.

It’s been an incredible and almost surreal week in the land of jet propulsion, and to try and summarize the emotions and sights into words is daunting, as the vocabulary escapes me.

It seems as though around every corner, you meet someone who is so friendly and inspiring that it’s hard not to just smile and try and listen in amazement. From sending beeps aimed at distant galaxies looking for anomalies in the return signal, to brilliant twenty-somethings building descent stage thrusters capable of hovering above the surface of Mars like a UFO, to the beautiful array of different languages and cultures you hear just on your way to the coffee grove, the people and mission here make it hard to contain a smile.

The department I’m writing from is the Deep Space Network (DSN), Antenna Mechanical Group, an incredibly diverse group of people who have welcomed me with open arms. Comprised of a complex network and interface of all different departments and jobs, the DSN is responsible for monitoring all spacecraft currently exploring the universe, searching the night sky for signals and pushing the envelope of what is possible for future communication and data acquisition.

I have an official government NASA office with a phone and voice mail to boot, and the speed and vigor at which things move around here is mind-blowing. It seems imperative to listen and write fast, even if what you’re hearing seems unreal or beyond belief, and before you know it, you’re neck deep in documents and learning curves that didn’t seem possible when you got out of bed this morning. The part I enjoy tremendously is walking outside my office and seeing my fellow DSN antenna mechanical office mates, who are mechanical, civil, structural, aerospace engineers, attacking a white dry erase board with looks of determination. They make cuts in beams, figure out angles and calculate distributed loads in order to find failure points for future antenna-component construction, all of which Effat Rady, my amazing engineering professor at Montana State University has taught me and stressed the importance of, time and time again. It seems as thought the days are lightning quick here, and the only thing I can seem to do after riding my bike home is run in the San Gabriel mountains as far as I can to try to process everything that happened in a day.

The Mars Science Laboratory rover, Curiosity, the largest and most intelligent rover to date, departed the Lab this morning after years of complete dedication and planning by thousands of people.

I was one of a handful of people who was lucky enough to witness the incredible entourage and police escort of the rover — sending it one step further on its quest to explore where Mankind has not yet set foot — as my mentor Jason Carlton was an integral part of the rover, descent stage, and heat shield container builds, assembly, and mating of all components with their transports. He is with the rover as I write this now, bound for the NASA’s Kennedy Space Center aboard an Air Force plane, probably forty-thousand feet above you.

As I write, I’m sitting in the Media Relations Office at JPL bouncing off the walls as my blog goes live, now getting to share this amazing experience and my enthusiasm for this wonderful launching pad of planetary exploration.

› Read Andrew’s full blog on the JPL Education website